InPower DSP-DCS1 Digital Battery Monitor and Alarm

Price: $191.67

InPower DSP-DCS1 Digital Battery Monitor and Alarm

Battery DC Voltage Display

Dual DC Ammeter Display

Backlit LCD Digital Display

Low Battery Voltage Alarm (KKK-A-1822F)

Auto-Configures Number of Ammeters

Uses Standard InPower DC Current Sensors

No Calibration Required

Customized Functions Available

Part Number: IP-DSP-DCS1

The item you are trying to purchase is currently out of stock.
Please enter your name, email, and phone number below.
We will contact you as soon as this product is available.

Name: *

Email: *

Phone: *

Verification: *

Type the word above...

Quantity

Description
Special Features

InPower DSP-DCS1 Digital Battery Monitor and Alarm

Digital battery monitor and alarm that displays voltage and current for up to two ammeters. Backlit liquid crystal display (LCD) is sunlight readable. A built-in low voltage output provided to meet KKK and NFPA requirements.
An alarm cancel input provided to silence alarm. Auto detects current sensors to adjust display for one or two current sensors.
Display voltage flashes during low voltage condition. Display voltage only when sensors are installed.
The InPower DSP-DCS1 is a multifunction instrument that includes a DC voltmeter and two ammeters. Its backlit liquid crystal display (LCD) is easy to read in low light as well as in direct sunlight. It includes a built-in low battery voltage alarm complying with Federal Specification KKK-A-1822F, Paragraph 3.7.6.2 (Voltmeter and Voltage Monitor). This alarm function provides a flashing battery voltage display and sets the alarm output (+12 volts @ 0.5 amps) when the battery voltage drops below 11.8 volts for 120 seconds. Additionally, the unit includes a Silence Alarm input. If the alarm output is set and a ground is applied to the Silence Alarm input, the alarm output will be turned off, but the voltage display will continue to flash until the battery voltage rises above 12.25 volts for two minutes.
The dual ammeter function utilizes InPower Model DCS-35-300- 1 Hall-effect current sensors to measure DC current in the range of -300 to +300 amps. As the system is pre-calibrated there is no need for adjustments at installation. The system provides an automatic configuration that detects if one, two, or no current sensors are connected, and automatically formats the digital display accordingly. For example, if no current sensors are detected the display will only show the battery voltage information.
The DSP-DCS1 battery monitor mounts easily on a flat panel with cutout. No fasteners are visible from the front. It contains 0.25 inch Faston male blade terminals on the rear of the unit for the interface connections.

InPower DSP-DCS1 Digital Battery Monitor and Alarm

InPower DSP-DCS1 Digital Battery Monitor and Alarm

Contact Information

INFORMATION AND CUSTOMER SERVICE